Actions

Zenitel Client IMT Configuration

From Zenitel Wiki

Revision as of 14:39, 3 March 2022 by Roarl (talk | contribs) (Created page with "{{EP}} In the special case of using VS-SDK for a Pulse-enabled project, VS-Client must be configured from the VS-IMT (Intercom Management Tool). The following settings are co...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
EP.png

In the special case of using VS-SDK for a Pulse-enabled project, VS-Client must be configured from the VS-IMT (Intercom Management Tool). The following settings are configurable:

  • General Settings: Directory Number, Display Name (Nickname on network), Server IP.
  • Audio Settings: Speaker and Microphone volume, Noise cancellation, Audio profile, Conversation mode.
  • Call Settings: Auto answer can be enabled.
  • Other Settings: Username and password.

See VS-IMT VS-SDK for Pulse System Setup for further details.

VS-IMT Configuration of VS-Client

This type of configuration should only be used if VS-SDK for Pulse is needed in the system. The standard way of configuring the VS-Client is via the application’s Account settings and station web interface on the Pulse Server device.

Note that Vingtor Stentofon ZAP Service needs to be running for this type of configuration. See Zenitel Client Installer for instructions about how to install Vingtor Stentofon ZAP Service.

Retrieved from "https://wiki.zenitel.com/w/index.php?title=Zenitel_Client_IMT_Configuration&oldid=227199"