%prci

The %prci macro is used in the Event Handler to check state of a physical input on a Zenitel IP Device.

Syntax

%prci(station,input_no)

Return 1 (active) or 0 (not active) state of a physical input

• station: Physical number 1 - 552
• input_no: Input number 1 - 8

IP-LCM:

• Input 1-6 are the inputs on the TKIS unit
• Input 8-15 are the extra 8 inputs on the IP-LCM main board

The inputs 8-15 on IP-LCM can be read by the %prci as from firmware version 9.0.3.3 One can use the Faulty Station Line - OFF together with %prci to read the status of the inputs when a device registers to the ICX-AlphaCom. However, one have to insert a small delay ($ST) of approx. 5 seconds from the device registers to the inputs are read.''

Examples

%prci(5,1)   - Return state of input 1 on station 5

Back to Event_Handler#List_of_context_parameters.