ZIPS - Relay, Inputs and Outputs
From Zenitel Wiki
This article shows how the relay, inputs and outputs of the ZIPS devices (ZIPS speakers and ZIPS-kits) are mapped when used with an ICX-AlphaCom server.
Inputs
The GPIO 1 and 2 are mapped to DAK 11 and to DAK 12 respectively.
Note that the first generation of ZIPS speakers had one GPIO only, which was mapped to DAK 11.
Relay
The relay must be mapped to Pin 7 in the RCO table in AlphaPro.
Outputs
The GPIO must set as "Output" in the device web interface of the ZIPS device.
The output must be mapped to the correct "Pin" number in the RCO table in AlphaPro:
- GPIO 1: Is mapped to Pin 1
- GPIO 2: Is mapped to Pin 2 (available on generation 2 of the ZIPS speakers)
- 24V beacon driver: Is mapped to Pin 8 (available on generation 2 of the ZIPS speakers)
The first generation of ZIPS speakers had one GPIO only, which must be mapped to Pin 1.