Difference between revisions of "ENA2060 Amplifier"
From Zenitel Wiki
(→Software Upgrade) |
(→Software Upgrade) |
||
| Line 28: | Line 28: | ||
*Factory Default values can be restored by shorting pins 7 and 13 in the Multi-Connector during boot and following the directions for [[TKIS Restore Factory Defaults]] | *Factory Default values can be restored by shorting pins 7 and 13 in the Multi-Connector during boot and following the directions for [[TKIS Restore Factory Defaults]] | ||
| − | *Factory Default values can also be loaded via the web interface of the amplifier, from the [[ | + | *Factory Default values can also be loaded via the web interface of the amplifier, from the [[ENA_Amplifier_Configuration_(SIP)#Recovery|Main > Recovery]] menu |
==Related Information== | ==Related Information== | ||
Revision as of 09:06, 27 June 2024
The ENA2060 Network Amplifier for Rolling Stock incorporates SIP-addressable loudspeaker loops that enable the use of the same software for handling both Passenger Emergency Intercom / Crew Communication and Public Address (PA), as well as the required Train Radio Integration, thus eliminating one entire subsystem from the solution.
This results in a well-integrated system with less complexity and more functionality, while the use of open standards offers freedom of choice when it comes to future upgrades and supply.
2 different ENA2060 models are available.
- ENA2060-DC1 uses a 110 VDC power source
- ENA2060-DC2 uses a 24-48 VDC power source
Contents
Installation, Mounting and Dimensions
Configuration
Software Upgrade
Software upgrade of the ENA2060 amplifier is done in the same way as Turbine Intercom stations.
Load Factory Default values:
- Factory Default values can be restored by shorting pins 7 and 13 in the Multi-Connector during boot and following the directions for TKIS Restore Factory Defaults
- Factory Default values can also be loaded via the web interface of the amplifier, from the Main > Recovery menu