Difference between revisions of "Increased volume on ringing signal"
From Zenitel Wiki
(→Increase Private Ringing signal) |
(→Increase Private Ringing signal) |
||
| Line 4: | Line 4: | ||
As from firmware version AMC 10.23 the volume to a station can be changed by the data command [[VOL]]. | As from firmware version AMC 10.23 the volume to a station can be changed by the data command [[VOL]]. | ||
| − | == | + | == Change the volume of the Private Ringing signal == |
By using the event type [[Private Ringing mode (Event Type)|9 - Private Ringing mode]] in the [[Event Handler]], one can set a higher volume during the ringing, and set it back to a normal level when the call is answered (i.e. when the Private Ringing mode goes off). | By using the event type [[Private Ringing mode (Event Type)|9 - Private Ringing mode]] in the [[Event Handler]], one can set a higher volume during the ringing, and set it back to a normal level when the call is answered (i.e. when the Private Ringing mode goes off). | ||
Revision as of 10:29, 5 April 2018
This article describes how to increase (or decrease) the volume of the private ringing signal, and set it back to normal when the call is answered (or canceled).
As from firmware version AMC 10.23 the volume to a station can be changed by the data command VOL.
Change the volume of the Private Ringing signal
By using the event type 9 - Private Ringing mode in the Event Handler, one can set a higher volume during the ringing, and set it back to a normal level when the call is answered (i.e. when the Private Ringing mode goes off).
In AlphaPro, go to Exchange and System -> Events, press Insert and create the following event:
| Event Owner: | Stations w/ UDP, Id: 8 (all stations) |
| Event type: | 09 - Private Ringing mode |
| When change to: | ON or OFF |
| When related to: | All |
| Action: | $VOL L%1.dir U%chg(6,3) |
When a station starts to ring the volume is set to level 6, and when the ringing stops the volume is set to level 3.
Change the volume of the "Call Request" tone
By using the event type 12 - Priority Mail in Idle in the Event Handler, one can change the volume when there are Call Requests in the queue, and set it to a different level when the call is answered.
In AlphaPro, go to Exchange and System -> Events, press Insert and create the following event:
| Event Owner: | Stations w/ UDP, Id: 8 (all stations) |
| Event type: | 12 - Priority Mail in Idle |
| When change to: | ON or OFF |
| When related to: | All |
| Action: | $VOL L%1.dir U%chg(6,3) |
When a station receives a Call Request the volume is set to level 6. During a call the volume is set to a different level.