Increased volume on ringing signal

This article describes how to increase (or decrease) the volume of the ringing signal or the Call Reqwuest tones, and set it back to normal when the call is answered (or canceled).

As from firmware version AMC 10.23 the volume to a station can be changed by the data command VOL.

Change the volume of the Private Ringing signal

By using the event type 9 - Private Ringing mode in the Event Handler, one can set a higher volume during the ringing, and set it back to a normal level when the call is answered (i.e. when the Private Ringing mode goes off).

In AlphaPro, go to Exchange and System -> Events, press Insert and create the following event:

---

Event Owner:	Stations w/ UDP, Id: 8 (all stations)
Event type:	09 - Private Ringing mode
When change to:	ON or OFF
When related to:	All
Action:	$VOL L%1.dir U%chg(6,3)

---

When a station starts to ring the volume is set to level 6, and when the ringing stops the volume is set to level 3.

Change the volume of the "Call Request" tone

By using the event type 12 - Priority Mail in Idle in the Event Handler, one can change the volume when there are Call Requests in the queue, and set it to a different level when the call is answered.

In AlphaPro, go to Exchange and System -> Events, press Insert and create the following event:

---

Event Owner:	Stations w/ UDP, Id: 8 (all stations)
Event type:	12 - Priority Mail in Idle
When change to:	ON or OFF
When related to:	All
Action:	$VOL L%1.dir U%chg(6,3)

---

When a station receives a Call Request the volume is set to level 6. During a call the volume is set to a different level.