Difference between revisions of "Touchless sensor (w/ backbox)"
From Zenitel Wiki
(→From Idle) |
(→Use Case Examples) |
||
| Line 47: | Line 47: | ||
More details can be found on [[Direct Access Key & Ringlist Settings (Edge)|Direct Access Key Settings]]. | More details can be found on [[Direct Access Key & Ringlist Settings (Edge)|Direct Access Key Settings]]. | ||
| + | |||
| + | === Configuration on ICX-AlphaCom === | ||
[[Category:Additional equipment]] | [[Category:Additional equipment]] | ||
Revision as of 12:16, 22 October 2020
The Touchless sensor (item 2390020100) is an IR-sensor that connects to Turbine Compact stations and is used to activate calls with gesture recognition instead of pressing the call button.
Contents
Highlights
- Input Voltage: 5V
- Available contacts: Normally Open & Normally Closed
- Operating distance 3 to 20 cm (adjustable)
- IP 66
Connections
Connections are made to the switch using the supplied 5 pin plug.
Correct orientation of the plug is ensured by the connector locating guides.
Color code
- Red - +5 Volt supply
- Brown - 0 Volt supply
- Green - Normally Closed
- Blue - Common
- Purple - Normally Open
Settings
Typical Application
Use Case Examples
Touchless sensor wired to Input 1 on a Turbine station:
Configuration on IC-Edge
To configure the Inputs select Edge Controller > System Configuration > Direct Access Keys.
Select Show/Hide Settings on the station you want to configure:
Inputs (and DAK keys) have two states:
- Idle: There is no active call on the station.
- Call: There is an incoming, outgoing or active call on the station.
From Idle
From IDLE state the following options are available (note that the available options will depend on the station type):
- Call To: Enter the directory number to call when the DAK key/Input is pressed. Extended call options (parallel ringing, call escalation, etc.)
More details can be found on Direct Access Key Settings.