Actions

Difference between revisions of "Remote setup of Alarm message feature"

From Zenitel Wiki

 
(12 intermediate revisions by 2 users not shown)
Line 1: Line 1:
 +
{{AI}}
 
{|  
 
{|  
 
|-
 
|-
Line 10: Line 11:
 
|'''Parameter 1''': || 0 (N/A)
 
|'''Parameter 1''': || 0 (N/A)
 
|-valign="top"  
 
|-valign="top"  
|'''Description''': || Remotely activate playback of [[alarm message]] to another station or [[group]] of stations. The feature requires [[ASVP]] board.
+
|'''Description''': || Remotely activate playback of [[alarm message]] to another station or [[groups|group]] of stations.  
 
Procedure:
 
Procedure:
* 761 + group + alarm message
+
* 761 + [[Group call feature|group]] + [[Start Alarm message at station feature|alarm message]]
 
* 761 + 85 + 8191: Turn on alarm message 8191 to stations in group 85
 
* 761 + 85 + 8191: Turn on alarm message 8191 to stations in group 85
 
* 761 + 85 + 8190: Turn off alarm message to stations in group 85
 
* 761 + 85 + 8190: Turn off alarm message to stations in group 85
 +
|}
 +
<br>
 +
This feature is by default available for [[SuperUser]] only.
 +
 +
Alarm messages can also be triggered from the [[Event Handler]] or [[RCI]] by using the commands [[AMS - Alarm Message to Station|AMS]] or [[AMG]], or the [[ACDP|AlphaCom Data Protocol]] command [[ALARM MSG|$ALRM]]
 +
<br><br>
 +
By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions for each alarm message. This must be done from the nvram editor in the [[TST console]].
  
Alarm messages can also be triggered from the [[Event Handler]] or [[RCI]] by using the commands [[AMS]] or [[AMG]], or the [[ACDP|AlphaCom Data Protocol]] command [[ALARM MSG|$ALRM]]
 
  
|}
 
  
  
|-
 
|colspan="2"|Play alarm message on group of stations.
 
  
Dial:  <dir.no> <group dir.no>
 
|-
 
|}
 
  
  
 
[[AlphaCom Feature List|Back to feature list]]
 
[[AlphaCom Feature List|Back to feature list]]

Latest revision as of 09:54, 5 May 2023

AI.png
Feature: Remote setup of Alarm Message
Default directory number: 761
Feature number: 68
Parameter 1: 0 (N/A)
Description: Remotely activate playback of alarm message to another station or group of stations.

Procedure:

  • 761 + group + alarm message
  • 761 + 85 + 8191: Turn on alarm message 8191 to stations in group 85
  • 761 + 85 + 8190: Turn off alarm message to stations in group 85


This feature is by default available for SuperUser only.

Alarm messages can also be triggered from the Event Handler or RCI by using the commands AMS or AMG, or the AlphaCom Data Protocol command $ALRM

By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions for each alarm message. This must be done from the nvram editor in the TST console.




Back to feature list