Difference between revisions of "Remote setup of Alarm message feature"
From Zenitel Wiki
| (18 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
| + | {{AI}} | ||
{| | {| | ||
|- | |- | ||
| Line 10: | Line 11: | ||
|'''Parameter 1''': || 0 (N/A) | |'''Parameter 1''': || 0 (N/A) | ||
|-valign="top" | |-valign="top" | ||
| − | |'''Description''': || Remotely activate playback of [[alarm message]] | + | |'''Description''': || Remotely activate playback of [[alarm message]] to another station or [[groups|group]] of stations. |
| − | Procedure: 761 + group + alarm message | + | Procedure: |
| − | + | * 761 + [[Group call feature|group]] + [[Start Alarm message at station feature|alarm message]] | |
| − | * 761 + 85 + 8191 | + | * 761 + 85 + 8191: Turn on alarm message 8191 to stations in group 85 |
| − | * 761 + 85 + 8190 | + | * 761 + 85 + 8190: Turn off alarm message to stations in group 85 |
| + | |} | ||
| + | <br> | ||
| + | This feature is by default available for [[SuperUser]] only. | ||
| − | + | Alarm messages can also be triggered from the [[Event Handler]] or [[RCI]] by using the commands [[AMS - Alarm Message to Station|AMS]] or [[AMG]], or the [[ACDP|AlphaCom Data Protocol]] command [[ALARM MSG|$ALRM]] | |
| + | <br><br> | ||
| + | By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions for each alarm message. This must be done from the nvram editor in the [[TST console]]. | ||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
[[AlphaCom Feature List|Back to feature list]] | [[AlphaCom Feature List|Back to feature list]] | ||
Latest revision as of 09:54, 5 May 2023
| Feature: | Remote setup of Alarm Message |
| Default directory number: | 761 |
| Feature number: | 68 |
| Parameter 1: | 0 (N/A) |
| Description: | Remotely activate playback of alarm message to another station or group of stations.
Procedure:
|
This feature is by default available for SuperUser only.
Alarm messages can also be triggered from the Event Handler or RCI by using the commands AMS or AMG, or the AlphaCom Data Protocol command $ALRM
By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions for each alarm message. This must be done from the nvram editor in the TST console.