Difference between revisions of "ENA Amplifier - Basic configuration (SIP mode)"
From Zenitel Wiki
(→Multicast Paging) |
|||
Line 1: | Line 1: | ||
{{S}} [[File:ENA SIP Drawing.png|thumb|800px|ENA Amplifiers i SIP mode]] | {{S}} [[File:ENA SIP Drawing.png|thumb|800px|ENA Amplifiers i SIP mode]] | ||
This article describes the basic configuration required for a Exigo Network Amplifier (ENA) to operate with an SIP server. The ENA Amplifiers are configured through their web interface. <br> | This article describes the basic configuration required for a Exigo Network Amplifier (ENA) to operate with an SIP server. The ENA Amplifiers are configured through their web interface. <br> | ||
− | For a more detailed description of various settings and options, see [[ENA Configuration | + | For a more detailed description of various settings and options, see [[ENA Amplifier Configuration (SIP)|Web interface - SIP mode]]. |
== Configure the amplifier == | == Configure the amplifier == |
Revision as of 14:40, 26 June 2024
This article describes the basic configuration required for a Exigo Network Amplifier (ENA) to operate with an SIP server. The ENA Amplifiers are configured through their web interface.
For a more detailed description of various settings and options, see Web interface - SIP mode.
Contents
Configure the amplifier
Registration Settings
Use the web browser on a PC to log on to the web interface of the amplifier, go to Main > Main Settings, and:
- Set Mode = "SIP"
- Select the preferred Internet Protocol (IPv4 or IPv6)
- Configure the IP Settings (IP address) of the amplifier
To find the IP address of the amplifier, use the Intercom Management Tool, IMT. On older ENA amplifiers with a front display use the Menu Selection Knob, and navigate to Information > Network. |
- Go to SIP Configuration -> Account/Call and configure relevnt parameters for the SIP account:
Configure Loudspeaker lines
In the Amplifier Settings > Line Control, you can configure Loudspeaker Line Voltage to 70 or 100V, enable or disable channels and set a master volume.
Multicast Paging
To enable and configure multicast paging, see Multicast Paging (Edge/SIP)