Difference between revisions of "Situations that require System Reset"
From Zenitel Wiki
(→Situations that require AMC application reset) |
(→Situations that require AMC application reset) |
||
Line 13: | Line 13: | ||
* Change of volume setting of an analog station (Changing the volume of an IP station do not require reset) | * Change of volume setting of an analog station (Changing the volume of an IP station do not require reset) | ||
* Enabling [[RCO]]. Reset is required when a RCO is changed from device 0 / pin 0. | * Enabling [[RCO]]. Reset is required when a RCO is changed from device 0 / pin 0. | ||
+ | * Adding a SIP node???? | ||
+ | * Adding a node in AlphaNet??? | ||
===Situations that require Linux reset=== | ===Situations that require Linux reset=== |
Revision as of 13:55, 12 December 2008
A number of AlphaPro settings require that the system is reset or rebooted in order to make the change to take effect.
There are two types of reset:
- Reset of the AMC application. This will restart the intercom application. A AMC reset takes approx. xx seconds in a fully equipped E7, and xx seconds in a fully equipped E26.
- From AlphaPro: Press the 'Reset' button in the AlphaPro Communication Window (WACS)
- From AlphaWeb: Press 'Small Reset' in menu System Maintenance -> System Recovery
- Reboot the exchange. This will restart the Linux operative system and all applications. A reboot takes approx. xx seconds in a fully equipped E7, and xx seconds in a fully equipped E26.
- From AlphaWeb: Press 'Reboot' in menu System Maintenance -> System Recovery
- Recycle the power (switch power off, then on)
Situations that require AMC application reset
- Adding a new IP station in Users & Stations
- Change of volume setting of an analog station (Changing the volume of an IP station do not require reset)
- Enabling RCO. Reset is required when a RCO is changed from device 0 / pin 0.
- Adding a SIP node????
- Adding a node in AlphaNet???
Situations that require Linux reset
Situations that don't require reset or reboot, but where the change take effect after a short time
- Event Handler programming. It may take up to 1 minute before the change takes effect. (After reset the change take effect immediately)