Difference between revisions of "RCO CHANGED"

Revision as of 10:47, 26 June 2018

RCO_CHANGED		0x0085
$RCOC W1 U1
RCO pin state reported from exchange. This message is now (since 2010?) sent automatically from the AlphaCom server as a respose to an RCO command or $SLRC command In earlier version (pre 2010) this message was not sent automatically, and had to be configured in Event Handler as “side effect” of RCO controlling actions
1	UINT2	Logical RCO number
2	UINT1	Change to state: 0 = pin is off 1 = pin is on

@@ Line 11: / Line 11: @@
 |colspan="5"|[[RCO]] pin state reported from exchange.
 * This message is now (since 2010?) sent automatically from the AlphaCom server as a respose to an [[RCO - Set Remote Control Output|RCO command]] or [[SET LOGICAL RCO|$SLRC command]]
-* In earlier version (pre 2010) this message was not sent automatically from the AlphaCom, and had to be configured in Event Handler as “side effect” of [[RCO]] controlling actions
+* In earlier version (pre 2010) this message was not sent automatically, and had to be configured in Event Handler as “side effect” of [[RCO]] controlling actions
 |-
 |align=center|1||[[UINT2]]||colspan="3"|Logical [[RCO]] number