Difference between revisions of "ENA Amplifier - Basic configuration (SIP mode)"
From Zenitel Wiki
(→Registration Settings) |
|||
Line 13: | Line 13: | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
− | {{note|To find the IP address of the amplifier, use the [[ENA User Interface|Menu Selection Knob]] | + | {{note|To find the IP address of the amplifier, use the Intercom Management Tool, IMT. On older ENA amplifiers with a front display use the [[ENA User Interface|Menu Selection Knob]], and navigate to '''Information''' > '''Network'''. }} |
+ | |||
* Go to '''SIP Configuration -> Account/Call''' and configure relevnt parameters for the SIP account: | * Go to '''SIP Configuration -> Account/Call''' and configure relevnt parameters for the SIP account: | ||
[[File:ENA account call.png|thumb|left|700px|The '''Account/Call Settings''' page]] | [[File:ENA account call.png|thumb|left|700px|The '''Account/Call Settings''' page]] | ||
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
<br> | <br> | ||
+ | |||
=== Configure Loudspeaker lines === | === Configure Loudspeaker lines === | ||
In the [[ENA_Configuration_-_SIP_mode#Line_Control|Amplifier Settings > Line Control]], you can configure Loudspeaker Line Voltage to 70 or 100V, enable or disable channels and set a master volume. | In the [[ENA_Configuration_-_SIP_mode#Line_Control|Amplifier Settings > Line Control]], you can configure Loudspeaker Line Voltage to 70 or 100V, enable or disable channels and set a master volume. |
Revision as of 09:33, 14 June 2024
This article describes the basic configuration required for a Exigo Network Amplifier (ENA) to operate with an SIP server. The ENA Amplifiers are configured through their web interface.
For a more detailed description of various settings and options, see ENA Configuration - SIP mode.
Contents
Configure the amplifier
Registration Settings
Use the web browser on a PC to log on to the web interface of the amplifier, go to Main > Main Settings, and:
- Set Mode = "SIP"
- Select the preferred Internet Protocol (IPv4 or IPv6)
- Configure the IP Settings (IP address) of the amplifier
To find the IP address of the amplifier, use the Intercom Management Tool, IMT. On older ENA amplifiers with a front display use the Menu Selection Knob, and navigate to Information > Network. |
- Go to SIP Configuration -> Account/Call and configure relevnt parameters for the SIP account:
Configure Loudspeaker lines
In the Amplifier Settings > Line Control, you can configure Loudspeaker Line Voltage to 70 or 100V, enable or disable channels and set a master volume.
Multicast Paging
To enable and configure multicast the advanced configuration mode must be enabled.
When advanced configuration mode are enabled go to SIP Configuration > Multicast Paging to enable and configure multicast.