ENA2100 - One Channel Mode

The ENA2100-AC Amplifier supports One Channel Mode.

When "One Channel mode" is activated, the two loudspeaker channels will play identical audio, and the audio will be in phase. One can then choose to use two separate loudspeaker loops, each with maximum 100W, or one can bridge the two output channels, and use one loudspeaker loop with up to 200W load.

Configuration

Log in to the ENA Amplifier. Select Amplifier Settings > Line Control, and enable One Channel Mode:

Enabling One Channel Mode

Status LED

There is a green LED inside the Amplifier, right behind the loudspeaker connector, which will turn ON when "One Channel mode" is active. The LED can be seen through the rear grille.

The OneChannel LED can be seen through the grille

It is recommended to check that the "OneChannel-LED" is turned ON before bridging the two channels.

Wiring

The bridging the two loudspeaker channels into one must be done by the installer, by shorting wires on the rear connector, or at external terminal blocks.

In case of 100V line:

• Short "Com"-terminal for Ch1 to "Com"-terminal for Ch2.
• Short "100V"-terminal for Ch1 to "100V"-terminal for Ch2.

In case of 70V line:

• Short "Com"-terminal for Ch1 to "Com"-terminal for Ch2.
• Short "70V"-terminal for Ch1 to "70V"-terminal for Ch2.

One Channel Mode - Connecting channel 1 and channel 2 in parallel

Additional information

When One Channel mode is used, you need amplifier license for one channel only.

"One Channel" mode is the same as "Mirror CH1 audio" in the ENA2200 and ENA2400 amplifiers.