Touchless sensor (w/ backbox)

Touchless sensor, item 2390020100

The Touchless sensor (item 2390020100) is an IR-sensor that connects to Turbine Compact stations and is used to activate calls with gesture recognition instead of pressing the call button.

Highlights

• Input Voltage: 5V
• Available contacts: Normally Open & Normally Closed
• Sensor active time: 0,5 secs
• Operating distance: 15cm
• IP66

Connections

Connections are made to the switch using the supplied 5 pin plug.
Correct orientation of the plug is ensured by the connector locating guides.

Color code

• Red - +5 Volt supply
• Brown - 0 Volt supply
• Green - Normally Closed
• Blue - Common
• Purple - Normally Open

Typical Application

Touchless sensor - general wiring

Use Case Examples

Touchless sensor wired to Input 1 on a Turbine station:

Touchless sensor - wiring example

Configuration on IC-Edge

• To configure the Input select Edge Controller > System Configuration > Direct Access Keys.
  
• Select Show/Hide Settings on the station you want to configure.
• Configure the Input to Call To, and enter the directory number to call when activated.

Input 1 configured to call number 13 when triggered

More details can be found on Direct Access Key Settings.

Configuration on ICX-AlphaCom

TO configure the input to call a preconfigured number:

1. Select Users & Stations
2. Select the intercom station with the touchless sensor connected
3. Open the DAK window
4. Select the tab DAK 11-20
5. On DAK 11 (= input 1) enter the directory number to call when the input is activated

Input 1 configured to call number 13 when triggered

More information is found under DAK programming.