Increased volume on ringing signal
From Zenitel Wiki
This article describes how to increase the volume of the private ringing signal, and set it back to normal when the call is answered (or canceled).
It also describes how a customized audio message can be played in the loudspeaker during the ringing sequence.
Increase volume on ringing signal
As from firmware version AMC 10.23 the volume to a station can be changed by the data command VOL. By using the event type 9 - Private Ringing mode in the Event Handler, one can set a higher volume during the ringing, and set it back to a normal level when the call is answered (i.e. when the Private Ringing mode goes off).
In AlphaPro, go to Exchange and System -> Events, press Insert and create the following event:
| Event Owner: | Stations w/ UDP, Id: 8 (all stations) |
| Event type: | 09 - Private Ringing mode |
| When change to: | ON or OFF |
| When related to: | All |
| Action: | $VOL L%1.dir U%chg(6,3) |
When a station starts to ring the volume is set to level 6, and when the ringing stops the volume is set to level 3.
Play a customized audio message during ringing
The audio file must be uploaded to the AMC-IP as an alarm message. A basic or enhanced audio message license is required.
In AlphaPro, go to Exchange and System -> Events, press Insert and create the following event:
| Event Owner: | Stations w/ UDP, Id: 8 (all stations) |
| Event type: | 09 - Private Ringing mode |
| When change to: | ON or OFF |
| When related to: | All |
| Action: | AMS %1.phy %chg(3,0) |
When a station starts to ring, alarm message number 3 will be palyed in the speaker. Alarm messages are using volume override by default, so the message will be played at maximum output level.