Difference between revisions of "Audio Program"
From Zenitel Wiki
(→Audio Program selection) |
(→Audio Program selection) |
||
| Line 5: | Line 5: | ||
To listen to an audio program, dial the program number (default 801 - 806). By default the audio program is temporarily disconnected during conversation, but remains on during Group Call. | To listen to an audio program, dial the program number (default 801 - 806). By default the audio program is temporarily disconnected during conversation, but remains on during Group Call. | ||
| − | To switch off | + | To switch off an audio program, press the C-key or dial 800. |
When lifting the handset the dialing tone is normally heard, replacing any program. To listen to the program with the handset off, simply hold the M-key down while lifting the receiver, and the dialing tone is not turned on. | When lifting the handset the dialing tone is normally heard, replacing any program. To listen to the program with the handset off, simply hold the M-key down while lifting the receiver, and the dialing tone is not turned on. | ||
Revision as of 01:14, 18 December 2007
The AlphaCom system is prepared for distribution of audio programs. There must be an external audio source as input to each program, a radio, CD-player, alarm device or other sound input.
A number of inputs for audio programs are available, depending on the system configuration. By default 6 audio program inputs are available via the APC board for the AlphaCom E20 and AlphaCom E26, and 2 audio program inputs for the AlphaCom E7. The number of audio program inputs can be expanded by using AGA board.
Contents
Audio Program selection
To listen to an audio program, dial the program number (default 801 - 806). By default the audio program is temporarily disconnected during conversation, but remains on during Group Call.
To switch off an audio program, press the C-key or dial 800.
When lifting the handset the dialing tone is normally heard, replacing any program. To listen to the program with the handset off, simply hold the M-key down while lifting the receiver, and the dialing tone is not turned on.
Program Step
You can step through a list of available programs by dialing 790 on your station. Program off (800) is always included in the list. There are two alternative program step sequences: 3 or 6 programs.
The sequences are after autoload :
- Program 1, 2, 3, 4, 5, 6 and off.
- Program 1, 2, 3 and off.
- The number of programs in each sequence is programmable. The sequence setting is valid for the entire system.
- Each station can choose between sequence 1 or 2.
Program step codes:
- 790 - step up
- 791 - step down
- 792 - restore last
Program Priority
Program can be given 4 different priority levels affecting the program in the following way:
| * low | the program is turned off during conversation. |
| * medium and high | the program remains on during conversations. |
| * alarm | activates the handset & volume override for InterGuard stations if the program is activated by remote set-up to Group. This is used to distribute an alarm message as a program. |
Turning on Programs at Other Stations
From selected stations, for example a control room station, you can remotely set up a program to another intercom station, or to a group of stations. To set up a program remotely to another station, dial 74, then the subscriber number and the program number. To set up a program to a group of subscribers, dial 75, the group number and the program number.
Additional Information
- It is possible to prevent stations from canceling programs.
- After a reset of the exchange, the program set-up is restored.
Software
- AMC 07.01 to prevent stations from canceling programs.