Difference between revisions of "Auto Answer (Edge)"
From Zenitel Wiki
| Line 3: | Line 3: | ||
There are different ways to configure the Auto Answer: | There are different ways to configure the Auto Answer: | ||
| − | |||
* From the display menu of the station | * From the display menu of the station | ||
* From the web interface of the Edge Controller | * From the web interface of the Edge Controller | ||
If you want to set a call in permanent Private Mode, see [[Private - Set Always Private]]. | If you want to set a call in permanent Private Mode, see [[Private - Set Always Private]]. | ||
| − | |||
| − | |||
| − | |||
== Set AutoAnswer from display menu == | == Set AutoAnswer from display menu == | ||
Latest revision as of 10:13, 22 February 2024
In an Edge System the Auto Answer (Private/Open mode) determines if a call should be ringing until the user accepts the call, or if the call should connect automatically without any ringing signal. When ringing, the user can accept the call by pressing the M-key or by lifting the handset.
There are different ways to configure the Auto Answer:
- From the display menu of the station
- From the web interface of the Edge Controller
If you want to set a call in permanent Private Mode, see Private - Set Always Private.
On a display station select the button "Menu" under the display.
In the menu choose Auto answer + Sel:
Use the navigation buttons to select AutoAnswer On or Off.
When AutoAnswer is ON, and the Time setting = 0, the call will connect immediately. It is possible to delay the connection be setting a time (in seconds). An incoming call will then ring for the set time, then automatically connect.
Save the settings when exiting the menus.
Set AutoAnswer from the web interface of the Edge Controller
Autoanswer is set in Edge Controller -> System Configuration -> Call and Audio.
