Difference between revisions of "Conversation Outgoing (Event Type)"
From Zenitel Wiki
(→PA subevents) |
(→Event description) |
||
| Line 2: | Line 2: | ||
{| | {| | ||
|- | |- | ||
| − | |width=" | + | |width="200pt"|'''Event Owner''': |
| − | + | |A station or an [[UDP]] group | |
|- | |- | ||
|'''Event type''': || 08 - Conversation Outgoing | |'''Event type''': || 08 - Conversation Outgoing | ||
|- | |- | ||
| − | |'''Subevent''': || 0 | + | |'''Subevent''': || '''0'''. Subevents 1 or 2 are used for group call features, see below |
|- | |- | ||
|'''When change to ON''': || Conversation start | |'''When change to ON''': || Conversation start | ||
Revision as of 11:09, 10 August 2010
Contents
Event description
| Event Owner: | A station or an UDP group |
| Event type: | 08 - Conversation Outgoing |
| Subevent: | 0. Subevents 1 or 2 are used for group call features, see below |
| When change to ON: | Conversation start |
| When change to OFF: | Conversation end |
| When related to: | The called station, group call or simplex conference |
PA subevents
Subevent 1 "PA Record"
of "Conversation_Outgoing" event is reported ON when entering the recording phase of Recall. Report OFF when leaving the recording phase. (Since 11.1.3.3)
Subevent 2 "PA Active"
of "Conversation_Outgoing" event is reported ON when the PA message is distributed to the group. Report OFF when group distribution is finished. This event is reported both for Recall, PA of prestored message and for Group call feature. (Since 11.1.3.3)
The "PA Active" subevent is always reported OFF before the main "Conversation_Outgoing" OFF event.
Application
- CRM IV LED control
- Call logging
- CCTV interfacing
- PA zone control
Additional information
- - Related event: "07 Conversation Incoming"
- - The event stays ON also during "Door opening" action.
- - The event is also triggered by local and global group calls, and when pressing M-key in a simplex conference
- - To filter away group calls and conferences: Set "Related to" = UDP 8 instead of "All"