Difference between revisions of "MPC Data Protocol"
From Zenitel Wiki
| (One intermediate revision by the same user not shown) | |||
| Line 3: | Line 3: | ||
The output is broadcast of exchange events like dialled digits, station busy/free, connection and transfers. Note that it’s possible to send additional data strings from the AlphaCom’s [[Event Handler]] on this port also. | The output is broadcast of exchange events like dialled digits, station busy/free, connection and transfers. Note that it’s possible to send additional data strings from the AlphaCom’s [[Event Handler]] on this port also. | ||
| − | The AlphaCom supports a subset of the MPC Data Protocol for backward compatibility. This allowed some TouchLine generation equipment like | + | The AlphaCom supports a subset of the MPC Data Protocol for backward compatibility. This allowed some TouchLine generation equipment like PNCI, MLH and CRMIII/IV to be used with the AlphaCom. |
As from software 11.2.3.5 the MPC input commands also support global numbers, i.e. the command will be routed to the correct node. | As from software 11.2.3.5 the MPC input commands also support global numbers, i.e. the command will be routed to the correct node. | ||
| Line 10: | Line 10: | ||
| − | [[Category: | + | [[Category:Protocols]] |
Latest revision as of 14:24, 7 September 2017
The AlphaCom supports a subset of the MPC data protocol used with the classic Stentofon TouchLine exchanges. As it allows control of the AlphaCom exchange by mapping MPC commands to AlphaCom commands one-to-one it can be thought of as a variant of the simple link layer, but only for single-exchange (not AlphaNet) applications.
The output is broadcast of exchange events like dialled digits, station busy/free, connection and transfers. Note that it’s possible to send additional data strings from the AlphaCom’s Event Handler on this port also.
The AlphaCom supports a subset of the MPC Data Protocol for backward compatibility. This allowed some TouchLine generation equipment like PNCI, MLH and CRMIII/IV to be used with the AlphaCom.
As from software 11.2.3.5 the MPC input commands also support global numbers, i.e. the command will be routed to the correct node.
See also: MPC data trace