MultiModule
From Zenitel Wiki
The STENTOFON AlphaCom E MultiModule function makes it possible to increase the capacity of an exchange by adding up to four AlphaCom E exchange cabinets together in a master-slave configuration. The multi-module exchange acts as one node with full integration of all features. In some documents multi-module is refered to as InterCardCage, ICC.
All configuration data are stored on the AMC-IP board in the master module. The master module controls the resources in the slave modules using the ICC Protocol.
Contents
Use MultiModule or AlphaNet?
In general MultiModule is recommended when the modules are located in the same room, and the purpose is to extend the line capacity.
AlphaNet is recommended when the modules are located apart from each other, in different floors, building or cities. In AlphaNet each module is a stand-alone exchange.
The main features of AlphaCom E IP-Based MultiModules are:
- Same high degree of feature integration as traditional MultiModules
- No additional AlphaCom hardware required
- Licenses are needed in each of the modules<br\>-The license key is common for AlphaNet and MultiModule<br\>-Licenses are by default used for MultiModule<br\>-MultiModule always use VoIP connections in a dynamic way
- Point to point connections (not in a ring as in traditional MultiModules)
- The modules do not need to be on the same LAN
- MultiModule uses fixed jitter buffer size of 10 ms
Autonom mode
The multi-module exchange supports redundancy mode. In case of master-slave communication error, the slave module will fallback to work as an individual exchange serving calls between stations connected directly to the exchange module. The AMC Master can be set to copy its content to the slave modules over a 28 hour period. In AlphaPro, Exchange & System > System > Calls & Options, set the flag "Autonom Mode: Copy NVRAM".
Module interconnections
IP network - VoIP
When using MultiModule over IP no additional AlphaCom hardware required. Conversations between modules are point to point, and not in a ring as in traditional MultiModule using AGA or AE1 boards.
The modules should be on the same LAN, as MultiModule uses fixed jitter buffer size of 10 ms
Cabling
The the modules together via a single Ethernet cable. Two modules can be connected back to back. A straight cat5 ethernet cable can be used. With three or four modules an ethernet switch is required.
Programming
Enter the IP address of the slave modules and connect
Licenses are required for each AlphaCom E module. Two modules can be connected back to back. A straight cat5 ethernet cable can be used. With three or four modules an ethernet switch is required.
- Perform a cold start to each module separately
- AlphaWeb:<br\>-Assign an IP Adress to each module<br\>-Enter the license key to enable the VoIP channels
- AlphaPro:<br\>-Enter the IP adress of the slave modules.
E1 link - AE1
Analog links - AGA
Installation
Limitations in Slave Modules
Slave modules support analogue stations only, no other types of inputs or outputs. Only the master module supports: