Difference between revisions of "RCO - Set Remote Control Output"
From Zenitel Wiki
| Line 1: | Line 1: | ||
| − | The RCO command is | + | The RCO command is for operation of [[RCO|Remote Control Outputs]], which is used for relay activation. |
== Syntax == | == Syntax == | ||
Revision as of 12:04, 24 September 2008
The RCO command is for operation of Remote Control Outputs, which is used for relay activation.
Syntax
RCO <RCO.logical.no> <ON/OFF> <Pulse time>
Example
RCO 10 - The RCO number 10 will follow the event ON and OFF RCO 10 ON – Turns ON the RCO number 10 RCO 10 ON 25 – Pulse RCO number 10 for 2.5 seconds