Difference between revisions of "RCO CHANGED"
From Zenitel Wiki
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
| − | {{ | + | {{AI}} |
{| border="1" | {| border="1" | ||
|- | |- | ||
| Line 11: | Line 11: | ||
|colspan="5"|[[RCO]] pin state reported from exchange. | |colspan="5"|[[RCO]] pin state reported from exchange. | ||
| − | This message is (since 2010?) sent automatically from the AlphaCom server to registered OPC devices on TCP ports 61112 and 61113 | + | This message is (since 2010?) sent automatically from the AlphaCom server to registered OPC devices on TCP ports 61112 and 61113 as a respose to an [[RCO - Set Remote Control Output|RCO command]] or [[SET LOGICAL RCO|$SLRC command]] |
|- | |- | ||
|align=center|1||[[UINT2]]||colspan="3"|Logical [[RCO]] number | |align=center|1||[[UINT2]]||colspan="3"|Logical [[RCO]] number | ||
Latest revision as of 16:05, 3 October 2019
| RCO_CHANGED | 0x0085 | 133 | AMC 08.10 | |
|---|---|---|---|---|
| $RCOC W1 U1 | ||||
| RCO pin state reported from exchange.
This message is (since 2010?) sent automatically from the AlphaCom server to registered OPC devices on TCP ports 61112 and 61113 as a respose to an RCO command or $SLRC command | ||||
| 1 | UINT2 | Logical RCO number | ||
| 2 | UINT1 | Change to state:
| ||