Difference between revisions of "Remote setup of Alarm message feature"
From Zenitel Wiki
| Line 10: | Line 10: | ||
|'''Parameter 1''': || 0 (N/A) | |'''Parameter 1''': || 0 (N/A) | ||
|-valign="top" | |-valign="top" | ||
| − | |'''Description''': || Remotely activate playback of [[alarm message]] to another station or [[groups|group]] of stations | + | |'''Description''': || Remotely activate playback of [[alarm message]] to another station or [[groups|group]] of stations. |
Procedure: | Procedure: | ||
* 761 + [[Group call feature|group]] + [[Start Alarm message at station feature|alarm message]] | * 761 + [[Group call feature|group]] + [[Start Alarm message at station feature|alarm message]] | ||
Revision as of 16:17, 16 May 2018
| Feature: | Remote setup of Alarm Message |
| Default directory number: | 761 |
| Feature number: | 68 |
| Parameter 1: | 0 (N/A) |
| Description: | Remotely activate playback of alarm message to another station or group of stations.
Procedure:
|
This feature is by default available for SuperUser only.
Alarm messages can also be triggered from the Event Handler or RCI by using the commands AMS or AMG, or the AlphaCom Data Protocol command $ALRM
By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions for each alarm message. This must be done from the nvram editor in the TST console.