Difference between revisions of "Remote setup of Alarm message feature"
From Zenitel Wiki
| Line 12: | Line 12: | ||
|'''Description''': || Remotely activate playback of [[alarm message]] to another station or [[groups|group]] of stations. The feature requires [[ASVP]] board. | |'''Description''': || Remotely activate playback of [[alarm message]] to another station or [[groups|group]] of stations. The feature requires [[ASVP]] board. | ||
Procedure: | Procedure: | ||
| − | * 761 + group + alarm message | + | * 761 + [[Group call feature|group]] + [[Start Alarm message at station feature|alarm message]] |
* 761 + 85 + 8191: Turn on alarm message 8191 to stations in group 85 | * 761 + 85 + 8191: Turn on alarm message 8191 to stations in group 85 | ||
* 761 + 85 + 8190: Turn off alarm message to stations in group 85 | * 761 + 85 + 8190: Turn off alarm message to stations in group 85 | ||
Revision as of 17:56, 25 January 2008
| Feature: | Remote setup of Alarm Message |
| Default directory number: | 761 |
| Feature number: | 68 |
| Parameter 1: | 0 (N/A) |
| Description: | Remotely activate playback of alarm message to another station or group of stations. The feature requires ASVP board.
Procedure:
|
Alarm messages can also be triggered from the Event Handler or RCI by using the commands AMS or AMG, or the AlphaCom Data Protocol command $ALRM
By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions. This must be done from the nvram editor in the TST console.