Difference between revisions of "Remote setup of Alarm message feature"
From Zenitel Wiki
Line 19: | Line 19: | ||
Alarm messages can also be triggered from the [[Event Handler]] or [[RCI]] by using the commands [[AMS]] or [[AMG]], or the [[ACDP|AlphaCom Data Protocol]] command [[ALARM MSG|$ALRM]] | Alarm messages can also be triggered from the [[Event Handler]] or [[RCI]] by using the commands [[AMS]] or [[AMG]], or the [[ACDP|AlphaCom Data Protocol]] command [[ALARM MSG|$ALRM]] | ||
<br><br> | <br><br> | ||
− | By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions. This must be done from the nvram editor in the [[TST console]]. | + | By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions for each alarm message. This must be done from the nvram editor in the [[TST console]]. |
Revision as of 17:57, 25 January 2008
Feature: | Remote setup of Alarm Message |
Default directory number: | 761 |
Feature number: | 68 |
Parameter 1: | 0 (N/A) |
Description: | Remotely activate playback of alarm message to another station or group of stations. The feature requires ASVP board.
Procedure:
|
Alarm messages can also be triggered from the Event Handler or RCI by using the commands AMS or AMG, or the AlphaCom Data Protocol command $ALRM
By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions for each alarm message. This must be done from the nvram editor in the TST console.