Difference between revisions of "SET LOGICAL RCO"
From Zenitel Wiki
(New page: {| border="1" align=left |- !style="background:#ffdead;" width="90pt" colspan="2"|SET_LOGICAL_RCO !style="background:#ffdead;" width="100pt"|0x006B !style="background:#ffdead;" width="30p...) |
|||
| Line 1: | Line 1: | ||
| − | {| border="1" | + | {| border="1" |
|- | |- | ||
!style="background:#ffdead;" width="90pt" colspan="2"|SET_LOGICAL_RCO | !style="background:#ffdead;" width="90pt" colspan="2"|SET_LOGICAL_RCO | ||
| Line 20: | Line 20: | ||
|- | |- | ||
|} | |} | ||
| + | |||
| + | |||
| + | [[AlphaNet_Data_Protocol#Remote_Control|Back to AlphaNet message list]] | ||
Revision as of 12:47, 17 July 2007
| SET_LOGICAL_RCO | 0x006B | 107 | AMC 07.00 | |
|---|---|---|---|---|
| $SLRC W2 U1<br\>$SLRC W2 U1 W10 | Set RCO #2 <br\>Set RCO #2 for 1 second | |||
| Set or clear a logical RCO. Mapping between logical and physical RCO is done by the exchange receiving this message. <br\>Note: COMMAND_RESPONSE is returned at the time the destination node receives the message, not after the RCOpin has been actually set/cleared. | ||||
| 1 | UINT2 | Logical RCO number. | ||
| 2 | UINT1 | New pin state:<br\>0 = turn output off <br\>1 = turn output on | ||
| 3 | UINT2 | Duration of pulse, in tenths of second. Optional, new in AMC 10.03. If Duration parameter is present, and non-zero, the RCO state specified in previous parameter lasts for the specified time. After the time has expired, the RCO is toggled to the opposite state. If a new $SLRC message on the same RCO arrives while the pulse timer is running, the timer is canceled, and the new message determines the new RCO state. Duration = 0 means infinite duration. | ||
| Response: | COMMAND_RESPONSE | |||