Situations that require System Reset

A number of AlphaPro settings require that the system is reset or rebooted in order to make the change to take effect. Reset of the system can be done from either the Alphacom Communication window, WACS or AlphaWeb.

There are two types of reset:

• Reset of the AMC application. This will restart the intercom application. A AMC reset takes approx. xx seconds in a fully equipped E7, and xx seconds in a fully equipped E26.
  • From AlphaPro: Press the 'Reset' button in the AlphaPro Communication Window (WACS)
  • From AlphaWeb: Press 'Small Reset' in menu System Maintenance -> System Recovery
• Reboot the exchange. This will restart the Linux operative system and all applications. A reboot takes approx. xx seconds in a fully equipped E7, and xx seconds in a fully equipped E26.
  • From AlphaWeb: Press 'Reboot' in menu System Maintenance -> System Recovery
  • Recycle the power (switch power off, then on)

Situations that require AMC application reset

• Adding a new IP station in Users & Statuions
• Change of volume setting of an analog station (Changing the volume of an IP station do not require reset)
• Enabling RCO. Reset is required when a RCO is changed from device 0 / pin 0.

Situations that don't require reset or reboot, but where the change take effect after a short time

• Event Handler programming. It may take up to 1 minute before the change takes effect. (After reset the change take effect immediately)