Situations that require System Reset

A number of AlphaPro settings require that the system is reset or rebooted in order to make the change to take effect.

There are two types of reset:

• Reset of the AMC application. This will restart the intercom application only. An AMC reset takes approx. xx seconds in a fully equipped E7, and xx seconds in a fully equipped E26.
  • From AlphaPro: Press the 'Reset' button in the AlphaPro Communication Window (WACS)
  • From AlphaWeb: Press 'Small Reset' in the System Maintenance -> System Recovery menu
• Reboot the exchange. This will restart the Linux operative system and all applications. A reboot takes approx. xx seconds in a fully equipped E7, and xx seconds in a fully equipped E26.
  • From AlphaWeb: Press 'Reboot' in the System Maintenance -> System Recovery menu
  • Recycle the power (switch power off, then on)

Situations that require AMC application reset

• Adding a new IP station in Users & Stations
• Change of volume setting of an analog station (Changing the volume of an IP station do not require reset)
• Enabling RCO. Reset is required when a RCO is changed from device 0 / pin 0.
• Adding a SIP node????
• Adding a node in AlphaNet???

Situations that don't require reset or reboot, but where the change take effect after a short time

• Event Handler programming. It may take up to 1 minute before the change takes effect. (After reset the change take effect immediately)