Difference between revisions of "Volume and handset override"
From Zenitel Wiki
| Line 11: | Line 11: | ||
* '''Prerecorded voice alarm messages''' (ASVP), remotly setup by: | * '''Prerecorded voice alarm messages''' (ASVP), remotly setup by: | ||
**The [[Start Alarm message at station feature|feature code 761]] | **The [[Start Alarm message at station feature|feature code 761]] | ||
| − | **The event handler commands [[AMS]] and [[AMG]], or | + | **The event handler commands [[AMS - Alarm Message to Station|AMS]] and [[AMG]], or |
**The [[ACDP]] data command [[ALARM_MSG|$ALRM]] | **The [[ACDP]] data command [[ALARM_MSG|$ALRM]] | ||
**The [[ACDP]] data command [[GROUP MSG|$GM]] when parameter 5 = 4. | **The [[ACDP]] data command [[GROUP MSG|$GM]] when parameter 5 = 4. | ||
Latest revision as of 10:54, 5 May 2023
Volume and handset override is a feature that forces the station volume to maximum level, and in case the handset is off-hook, it will reconnect the loudspeaker by forcing the station to go on-hook. The feature is applicable for analog display stations and all types of IP stations.
Volume and handset override is activated by the following features:
- Group calls with Alarm priority
- Audio Program, remotly setup to group, activated by:
- Using feature code 75
- Event handler command PRG, or
- ACDP command $PROG.
- In AlphaPro the audio program must have the flag Volume/Handset Override enabled.
- Prerecorded voice alarm messages (ASVP), remotly setup by:
|
Analog stations without display data receiver inside do not support handset and volume override.(E.g. models 1007034210, 1007036210, VMP-619 and 1007001210). |
See also: $MVO - Mask handset and volume override