ICX-510 (Zenitel Connect)
From Zenitel Wiki
The ICX-510 Server is the latest generation Intelligent Communications Platform from Zenitel. This article gives a general description of the hardware, and how to get started with the configuration of the system.
Description
Front view
 |
| ICX-510 Front view |
| Item | Description | Comment |
| 1 | Power LED | Steady green when power is applied to the ICX-510 |
| 2 | Status LED | Flashing green when the ICX-510 is running |
| 3 | Fault LED | Steady amber when the system reports an error. The LED will be lit during application or system reset, or if there is a temperature alarm. |
| 4 | Active LED | - |
| 5 | Link LED | Steady green when the ethernet link 0 or 1 is up. There is one LED for each ethernet port |
| 6 | RX/TX LED | Flashing when receiving or transmitting data on ethernet port 0 or 1. |
| 7 | Securing hole | 2 x screw holes, diagonally placed, for M4 screws. Used for rack mounting |
Rear view
 |
| ICX-510 Rear view |
| Item | Description | Type | Comment |
| 1 | Status LED | - | Indicates the same as the LED lights on the front of the box. |
| 2 | Ethernet port | Eth0/Eth1 | Two 1Gbps ethernet interfaces. Each Ethernet port is equipped with LED indicators for link and activity. |
| 3 | Power In | 24-48VDC | ICX-510 is powered from a DC power supply with nominal voltage 24VDC or 48VDC (Min/Max: 20VDC-63VDC) |
| 4 | Console port RS232 | RJ45 | RS232 port is the RJ45 part of the dual connector RS232/USB. This is a console port for debugging purposes. Com parameters: 115.200 baud, 8 data bits, no parity, 1 stop bit. |
| 5 | USB A port | - | - |
| 6 | USB Micro-B | - | - |
| 7 | Fault Relay | 3 pole terminal block | The fault relay will trigger when the system reports an error. In normal operation the relay is energized, which means it will also trigger on power outage. The relay reports fault:
|
| 8 | SD card slot | Micro SD card | Used for system recovery (Behind protection lid) |
| 9 | Factory Default Button | Tact switch | Used for resetting ICX-510 to factory default settings |
Mounting and Installation
Please see the ICX-510 Mounting & Installation Manual
Start up and initial configuration
- Power up the ICX-510 Server
- Watch the LEDs. During startup the Power LED and the Fault LED will be lit. The system uses approx. 2 minutes to start up. When up and running, the green status LED will start flashing.
- Connect your laptop to Ethernet port 0 (Eth 0) of the ICX-510 unit. Open a web browser (e.g. Chrome or Firefox), and enter the IP address of the ICX-510 in the address bar. The default IP address is 169.254.1.5, with subnet mask 255.255.0.0. Default username and password: admin/admin. Make sure your laptop is in the 169.254.x.x range.
- For further details, see the Getting Started article.
Factory Reset
In case there is a need to restore factory settings, there are two options:
- Factory reset from the Zenitel Connect web interface
- Hardware reset by using the reset button on the rear side of the ICX-510 unit
For details, see Factory Reset and Reboot