Difference between revisions of "Main Settings - Edge Controller"
From Zenitel Wiki
| Line 16: | Line 16: | ||
* '''DHCP''' – Select this option if the IP station shall receive IP Settings from a DHCP server. | * '''DHCP''' – Select this option if the IP station shall receive IP Settings from a DHCP server. | ||
* '''Static IP''' – Select this option if the IP station shall use a static IP address. Enter values for: | * '''Static IP''' – Select this option if the IP station shall use a static IP address. Enter values for: | ||
| − | + | ** '''IP-address''' | |
| − | + | ** '''Subnet-mask''' | |
| − | + | ** '''Gateway''' | |
| − | + | ** '''DNS Server 1''' (option for network administration) | |
| − | + | ** '''DNS Server 2''' (option for network administration) | |
| − | + | ** '''Hostname''' (option for network administration) | |
* '''Disable Reset to Factory default settings using frontboard and I/O :''' If enabled, factory reset will only be possible from StationWeb. This is disabled by default. | * '''Disable Reset to Factory default settings using frontboard and I/O :''' If enabled, factory reset will only be possible from StationWeb. This is disabled by default. | ||
Revision as of 15:12, 11 March 2019
|
This article is under construction! |
This article describes how to configure a Turbine device as an Edge Controller.
|
You can do all configuration of your devices from the EDGE Controller. There is no need to log on to each device |
- Logging on to the device you will use as the EDGE Controller
- Select Main > Main Settings to access the page for configuring station mode and Network Settings.
Station Mode: Select the mode: Edge Controller
Product Model And Accessory [Turbine only]: Depending on the type of Turbine hardware, there are different Product models and accessories to choose from. Find your model here: Turbine Station Models
IP Settings:
- DHCP – Select this option if the IP station shall receive IP Settings from a DHCP server.
- Static IP – Select this option if the IP station shall use a static IP address. Enter values for:
- IP-address
- Subnet-mask
- Gateway
- DNS Server 1 (option for network administration)
- DNS Server 2 (option for network administration)
- Hostname (option for network administration)
- Disable Reset to Factory default settings using frontboard and I/O : If enabled, factory reset will only be possible from StationWeb. This is disabled by default.
- Read IP Address [Turbine only]: Check the Read IP Address box to enable an unregistered station to speak the IP address when the call button is pressed. "Read IP Address" is default enabled.
- Enable RSTP [Turbine only] (for Industrial & Ex stations): Check the Enable RSTP box to enable RSTP. RSTP is only required when using redundant networking
- Ethernet Speed 10 Mbits/s [Turbine only]: Enable in some rare cases where it is not convenient to use 100 MBit/s Ethernet speed. Default Ethernet speed is 100 Mbit/s unless switch is configured to 10 Mbit/s.
Click Save to apply the new configuration settings.