Difference between revisions of "Dynamic group call"

Revision as of 12:00, 27 May 2021

Press a dedicated "Group Configursation" DAK key. The red led in key starts flashing, and the Dynamic Group is emptied.
Select stations or local groups to be included by pressing the associated DAK keys. A steady green led in the keys indicates that the stations/groups are included
Press the "Group Configuration" button again, and the group call is activated (the ding-dong chime is played). Pressing the `M`-key opens the microphone.
The green leds continue to be lit during the group call
Cancel the group call by pressing the `C`-key. The green LEDs are turned off.

For best performance it is recommended to use CRM V station or ECPIR-3P panel, as these devices have buttons with LEDs showing status.

Assign directory number 9535 to DAK 1 of the operator station. This is the Group Configuration button. Directory number 9535 is included by default.

DynGrp DAK.PNG

Each operator station is assigned its own Dynamic Group Call by entering the Dynamic Group Call number in the User Defined Parameter (%1.EXP) field of the operator.
Include operator stations in UDP group 1. Name the UDP group e.g. "Operators".

DynGrp UDP.PNG

In AlphaPro, go to Exchange and System -> Events, press Insert and create the following events:

IF %chg(1,0) IND %1.phy 0 0 0 OFF $GRM LV L%1.exp U3 IND %1.phy %1.dak(I%2.dir) 1 3 ON ENDIF

IF %chg(0,1) IND %1.phy %1.dak(I%2.dir) 1 3 ON $ST L%1.dir W10 L%1.exp ENDIF

@@ Line 25: / Line 25: @@
 In [[AlphaPro]], go to [[Exchange_%26_System_%28AlphaPro%29#Events|Exchange and System -> Events]], press Insert and create the following events:
+IF %chg(1,0)
+IND %1.phy 0 0 0 OFF
+$GRM LV L%1.exp U3
+IND %1.phy %1.dak(I%2.dir) 1 3 ON
+ENDIF
+IF %chg(0,1)
+IND %1.phy %1.dak(I%2.dir) 1 3 ON
+$ST L%1.dir W10 L%1.exp
+ENDIF