Difference between revisions of "Door Opening using Dummy Number (Event Handler)"
From Zenitel Wiki
| Line 12: | Line 12: | ||
In [[AlphaPro]], [[Directory_%26_Features_%28AlphaPro%29|Directory & Features]], press "Insert" to create a directory number, feature 105, for each door. Directory number 9545 is included by default.<br> | In [[AlphaPro]], [[Directory_%26_Features_%28AlphaPro%29|Directory & Features]], press "Insert" to create a directory number, feature 105, for each door. Directory number 9545 is included by default.<br> | ||
In [[AlphaPro]], go to [[Exchange_%26_System_%28AlphaPro%29#Events|Exchange and System -> Events]], press Insert and create the following event: | In [[AlphaPro]], go to [[Exchange_%26_System_%28AlphaPro%29#Events|Exchange and System -> Events]], press Insert and create the following event: | ||
| − | + | ||
| − | [[ | + | [[File:Application9a.png|500px|left|thumb|Event Handler configuration]] |
<br style="clear:both;" /> | <br style="clear:both;" /> | ||
{| | {| | ||
|- | |- | ||
| − | | | + | | [[RCO]] 4 ON 20 |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
|- | |- | ||
| − | + | | [[DISCON_ST|$DISCON_ST]] L%1.dir U2 | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
|- | |- | ||
|} | |} | ||
| − | |||
| − | |||
| − | |||
Subevent 6: Digit 6 | Subevent 6: Digit 6 | ||
When Change to ON: When the digit is pressed (not released) | When Change to ON: When the digit is pressed (not released) | ||
| − | RCO | + | RCO 4 ON 20: Pulse RCO 4 for 2.0 seconds |
$[[DISCON_ST]] L%1.dir U2: Disconnect the station with successtone | $[[DISCON_ST]] L%1.dir U2: Disconnect the station with successtone | ||
Revision as of 13:38, 24 May 2022
Situation
Some gates are not equipped with door stations, but the operator should use the same Door opening procedure to open the door.
Solution
When the operator gets a signal that there is someone at the door he should dial a 'dummy' number, then press digit 6 to operate a relay output (i.e. a RCO). In the example below any station can dial 9545 + 6 to trigger RCO 4 for 2 seconds, and disconnect with success-tone. Use the two-step event trigger, feature 105.
Programming
In AlphaPro, Directory & Features, press "Insert" to create a directory number, feature 105, for each door. Directory number 9545 is included by default.
In AlphaPro, go to Exchange and System -> Events, press Insert and create the following event:
| RCO 4 ON 20 |
| $DISCON_ST L%1.dir U2 |
Subevent 6: Digit 6 When Change to ON: When the digit is pressed (not released) RCO 4 ON 20: Pulse RCO 4 for 2.0 seconds $DISCON_ST L%1.dir U2: Disconnect the station with successtone