Difference between revisions of "Password (IP Stations)"
From Zenitel Wiki
(→Firmware version 7.5 and higher) |
|||
| Line 14: | Line 14: | ||
*'''Confirm New Password:''' The new password must be confirmed to avoid misprint | *'''Confirm New Password:''' The new password must be confirmed to avoid misprint | ||
| − | == Password requirements == | + | === Password requirements === |
| − | ===Firmware version 7.5 and higher=== | + | ====Firmware version 7.5 and higher==== |
* Length: minimum 8 - max. 32 characters | * Length: minimum 8 - max. 32 characters | ||
* At least 3 of the following 4 criteria must be met: | * At least 3 of the following 4 criteria must be met: | ||
| Line 27: | Line 27: | ||
A Factory Reset will reset to default password. | A Factory Reset will reset to default password. | ||
| − | ===Firmware version 7.4 and lower === | + | ====Firmware version 7.4 and lower ==== |
* Password can contain numbers and letters only, no other symbols allowed. | * Password can contain numbers and letters only, no other symbols allowed. | ||
* Maximum length is 10 characters. | * Maximum length is 10 characters. | ||
Revision as of 15:06, 25 May 2023
The password of an IP Station can be changed by:
- Log into the IP Station
- Select Station Administration > Change Password.
Contents
Web Password
The Web Password is the password you need to use in the web browser of your PC to get access to the web interface of an IP station.
- User: The default username admin can be changed here
- Old Password: Enter the old password for security. Default is alphaadmin
- New Password: Enter a new password
- Confirm New Password: The new password must be confirmed to avoid misprint
Password requirements
Firmware version 7.5 and higher
- Length: minimum 8 - max. 32 characters
- At least 3 of the following 4 criteria must be met:
- 1 Digit
- 1 Capital letter
- 1 Small letter
- 1 Special character
Special characters are: ?!@$%*,-.
A Factory Reset will reset to default password.
Firmware version 7.4 and lower
- Password can contain numbers and letters only, no other symbols allowed.
- Maximum length is 10 characters.
A factory reset will reset to default password.
In INCA stations with software version 01.06 and earlier the default username was ADMIN and the password was alphacom.
Offline Password
This setting is available for INCA Stations only. The Offline password is dialed on the station keypad to get access to the display setup menus. Default password is 1851.
In INCA stations with software version 01.06 and earlier the offline password was 1234.