Difference between revisions of "RCO - Set Remote Control Output"
From Zenitel Wiki
(→Example) |
|||
Line 10: | Line 10: | ||
RCO 10 ON – Turns ON the RCO number 10 | RCO 10 ON – Turns ON the RCO number 10 | ||
RCO 10 ON 25 – Pulse RCO number 10 for 2.5 seconds | RCO 10 ON 25 – Pulse RCO number 10 for 2.5 seconds | ||
+ | |||
+ | |||
+ | == Application example == | ||
+ | [[Pulsing of RCO (Event Handler)]] | ||
+ | |||
[[Category:Event Handler]] | [[Category:Event Handler]] | ||
[[Category:Built-In Action Commands]] | [[Category:Built-In Action Commands]] |
Revision as of 13:18, 7 June 2013
The RCO command is used for controlling Remote Control Outputs (RCOs), which is used for operating relays on the MRBD board, the FBSAR board or the relay in the IP station.
Syntax
RCO <RCO logical number> <ON/OFF> <Pulse time>
Example
RCO 10 - The RCO number 10 will follow the event ON and OFF RCO 10 ON – Turns ON the RCO number 10 RCO 10 ON 25 – Pulse RCO number 10 for 2.5 seconds