Difference between revisions of "Door Opening using Dummy Number (Event Handler)"
From Zenitel Wiki
(→Explanation) |
(→Programming) |
||
| Line 12: | Line 12: | ||
In [[AlphaPro]], go to [[Exchange_%26_System_%28AlphaPro%29#Events|Exchange and System -> Events]], press Insert and create the following event: | In [[AlphaPro]], go to [[Exchange_%26_System_%28AlphaPro%29#Events|Exchange and System -> Events]], press Insert and create the following event: | ||
------------ | ------------ | ||
| − | [[Image:Event 25 Event trigger w Parameter.jpg|thumb| | + | [[Image:Event 25 Event trigger w Parameter.jpg|thumb|left|500px|Event Handler configuration]] |
| + | <br style="clear:both;" /> | ||
{| | {| | ||
|- | |- | ||
| Line 31: | Line 32: | ||
|- | |- | ||
|} | |} | ||
| − | + | ||
------------ | ------------ | ||
Revision as of 13:37, 17 September 2013
Situation
Some gates are not equipped with door stations, but the operator should use the same Door opening procedure to open the door.
Solution
When the operator gets a signal that there is someone at the door he should dial a 'dummy' number, then press digit 6 to operate a relay output (i.e. a RCO). In the example below any station can dial 9545 + 6 to trigger RCO 4 for 2 seconds, and disconnect with success-tone. Use the two-step event trigger, feature 105.
Programming
In AlphaPro, Directory & Features, press "Insert" to create a directory number, feature 105, for each door. Directory number 9545 is included by default.
In AlphaPro, go to Exchange and System -> Events, press Insert and create the following event:
| Event Owner: | The operator station or a UDP group |
| Event type: | 25 – Event Trigger w/User Parameter |
| Subevent: | 6 |
| When change to: | ON |
| When related to: | Directory number, Id: 9545 |
| Action: | RCO 4 ON 20 |
| $DISCON_ST L%1.dir U2 |
Explanation
Subevent 6: digit 6 When Change to ON: When the digit is pressed (not released) RCO 6 ON 20: Pulse RCO 6 for 2,0 seconds $DISCON_ST L%1.dir U2: Disconnect the station with successtone