Actions

Difference between revisions of "Starting Up Turbine Station"

From Zenitel Wiki

Line 1: Line 1:
 
{{AEIPS}}
 
{{AEIPS}}
[[File:StartUp Z-device.PNG|thumb|right|400px|Connecting the PC and the Zenitel IP device to a network switch]]
+
[[File:StartUp Z-device.PNG|thumb|right|400px|Connect the PC and the Zenitel IP device to a network switch]]
 
The [[:Category:Stations#Turbine_stations|Zenitel IP devices]] feature an embedded web interface, which allows users to log in using a standard web browser.  
 
The [[:Category:Stations#Turbine_stations|Zenitel IP devices]] feature an embedded web interface, which allows users to log in using a standard web browser.  
  

Revision as of 10:41, 21 September 2021

AEIPS.png
Connect the PC and the Zenitel IP device to a network switch

The Zenitel IP devices feature an embedded web interface, which allows users to log in using a standard web browser.

To access the IP device, your PC and the device have to be connected to a PoE switch using network cables:

  1. Connect the PC to a port on the network switch
  2. Connect the deviceto a PoE port on the network switch


When the IP device is connected to the network, the IP address of the device is automatically obtained in one of two ways:

  1. An IP address is automatically obtained from a DHCP server if there is one.
  2. If there is no DHCP server, a random IP address in the range 169.254.x.x will be assigned.
Note icon The INCA series of devices have a default static IP address 169.254.1.100.



How to find the IP Address of a device

If the device is not registered to a server, it will speak its own IP address when you press the Call button, a Digit key a DAK key or activate an Input.

During commissioning, the device must be set to operate in the required mode. There are three modes of operation:

  • ICX-AlphaCom mode - the device will register to an ICX-AlphaCom or AlphaCom XE server
  • SIP mode - the device will register to a SIP server
  • Edge mode - the device will register to an Edge server

The default mode from factory is "Edge" mode.

As an alternative you can use the PC application IMT (Intercom Management Tool). Start IMT, select Discover & Upgrade from main menu, and enter IP address range to scan.

As soon as you know the IP address, you can log into the device.