%prci: Difference between revisions
From Zenitel Wiki
No edit summary |
No edit summary |
||
| Line 14: | Line 14: | ||
{{note| | {{note| | ||
*''One can use the [[Faulty Station Line (Event Type)|Faulty Station Line - OFF]] together with %prci to read the status of the inputs when a device registers to the ICX-AlphaCom. However, one have to insert a small delay ([[SET TIMER|$ST]]) of approx. 5 seconds from the device registers to the inputs are read.'' | *''The inputs 8-15 on IP-LCM can be read by the %prci as from firmware version 9.0.3.3<br> | ||
*''One can use the [[Faulty Station Line (Event Type)|Faulty Station Line - OFF]] together with %prci to read the status of the inputs when a device registers to the ICX-AlphaCom. However, one have to insert a small delay ([[SET TIMER|$ST]]) of approx. 5 seconds from the device registers to the inputs are read.''}} | |||
==Examples== | ==Examples== | ||
Latest revision as of 15:09, 4 December 2024
The %prci macro is used in the Event Handler to check state of a physical input on a Zenitel IP Device.
Syntax
%prci(station,input_no)
Return 1 (active) or 0 (not active) state of a physical input
- station: Physical number 1 - 552
- input_no: Input number 1 - 8
IP-LCM:
- Input 1-6 are the inputs on the TKIS unit
- Input 8-15 are the extra 8 inputs on the IP-LCM main board
|
|
Examples
%prci(5,1) - Return state of input 1 on station 5