Difference between revisions of "Software Upgrade (Edge)"

Revision as of 10:38, 7 October 2020

The software of the Vingtor-Stentofon devices in an IC-EDGE System can be mass upgraded in two ways. Either:

If upgrading an existing Pulse System, make sure that the Edge Controller is a Turbine device. An INCA device cannot serve as an Edge Controller, even if it was acting as a Pulse Server in the existing installation

For a detailed procedure, see the VS-IMT Upgrade Stations

A TFTP Server must be available. A TFTP server can be downloaded from here: http://tftpd32.jounin.net/tftpd32_download.html.
Download the Software Package for IC-Edge
Unzip the software package and store the files in a folder on your laptop.
The firewall on the laptop must not blocking incoming ping/ICMP (Turbine station is pinging TFTP Server during update process)

Start the TFTP server program and click Browse, and select the folder where the software files are located

TFTP Server - Browse to the folder where the software files are located

Start a web browser (e.g. Firefox or Chrome), and Log on to the Edge Controller. Select Edge Controller > Software Upgrade
Enter the IP address of the TFTP server (I.e. the IP address of your laptop)
Enter the Image File name, e.g vsft-5.1.3.0
When updating INCA devices, also a Checksum must be entered. Leave the Checksum field blank when upgrading Turbine devices.
- The checksum is found in a text file in the software folder, e.g. "A100G80200.02_11_3_0.txt". Open this file and make a note of (or copy to the clipboard) the checksum.
Select which stations to upgrade, and click Upgrade.

Enter TFTP server, firmware name and check which stations to upgrade

The upgrade procedure takes about 3 minutes. The process can be monitored by clicking the Log viewer tab in the TFTP server program.

Do not unplug devices during the upgrade!
It is recommended to use the same software version in all devices
After having upgraded Turbine devices from version 4.x to version 5.x, a factory default is recommended for all new settings and features to take effect
After having upgraded INCA devices from version 2.x to version 2.10, a factory default is recommended for all new settings and features to take effect

If video is not working after having upgraded the Turbine Video Station TCIV-x, see article TCIV - No video after upgrading

This article is linked to from the document A100K11980

@@ Line 28: / Line 28: @@
 * Start a web browser (e.g. Firefox or Chrome), and [[Logging into an IP Station|Log on to the Edge Controller]]. Select '''Edge Controller''' > '''Software Upgrade'''
 * Enter the IP address of the '''TFTP server''' (I.e. the IP address of your laptop)
-* Enter the '''Image File''' name, e.g '''vsft-5.0.3.0'''
+* Enter the '''Image File''' name, e.g '''vsft-5.1.3.0'''
 * When updating [[:Category:Stations#INCA_stations|INCA devices]], also a '''Checksum''' must be entered. Leave the Checksum field blank when upgrading [[:Category:Stations#Turbine_stations|Turbine devices]].
-**  The checksum is found in a text file in the software folder, e.g. "A100G80200.03_0_3_0.txt". Open this file and make a note of (or copy to the clipboard) the checksum.
+**  The checksum is found in a text file in the software folder, e.g. "A100G80200.02_11_3_0.txt". Open this file and make a note of (or copy to the clipboard) the checksum.
 * Select which stations to upgrade, and click '''Upgrade'''.