Actions

CANCEL MAIL

From Zenitel Wiki

Revision as of 15:27, 21 June 2007 by Asle (talk)
SEND_TXT_MAIL 0x0032 50 AMC 05.00
$CANM L101 L102 NM255 U255<br\>$CANM L101 L102<br\>$CANM LV L102 cancel specified mail/priority, here all<br\>cancel all mails from this sender<br\>cancel all mails in destination’s queue
Delete one or more mail/call request/alarm messages queued at a station.<br\><br\>

Note to Simple Link Layer format: Sender must be Dir.no. 07.60-08.00: Sender must contain node no L(1)101.<br\>$CANM is inverse of built-in command MST, but note that sender and receiver is swapped!

1 NET_OBJ_REF<br\>{ECL_STATION} Sender (source) station<br\>

NULL (LV) can be used e.g. for technical alarms, or if call-back is not desired.

2 NET_OBJ_REF<br\>{ECL_STATION,<br\>ECL_ST_GROUP} Receiver (destination) queuing station or local group.<br\>.<br\>.
3 NET_OBJ_REF
{ECL_MAIL}<br\>.<br\>.<br\>(optional AMC 08.01)
Mail message to be deleted. See page 17.<br\>Mail­-id values are:

<br\>1-32 = Standard mails, i.e. cancel a specific mail from this sender <br\>254 = MAIL_TYPE_CALL_BACK, i.e. cancel any call_back mail <br\>255 = any mail, i.e. cancel all mails from this sender

4 UINT1<br\>(Optional AMC 08.01) Priority threshold, i.e. delete only mail messages with priority below. <br\>255 = cancel all mails from this sender.
5 UINT1<br\>(optional) Hop Count. AlphaNet: Used to avoid endless mail forwarding. Incremented by AMC, discarded when too large. Default value = 0.
Response: COMMAND_RESPONSE- the option field is unused