RCO - Set Remote Control Output
From Zenitel Wiki
The RCO command is used for controlling Remote Control Outputs (RCOs), which again is used for operating relays on the MRBD board or the relay in the IP station.
Syntax
RCO <RCO.logical.no> <ON/OFF> <Pulse time>
Example
RCO 10 - The RCO number 10 will follow the event ON and OFF RCO 10 ON – Turns ON the RCO number 10 RCO 10 ON 25 – Pulse RCO number 10 for 2.5 seconds