Main Settings - Edge Controller

This article is under construction!

This article describes how to configure a Turbine device as an Edge Controller.

You can do all configuration of your devices from the EDGE Controller. There is no need to log on to each device

• Logging on to the device you will use as the EDGE Controller
• Select Main > Main Settings to access the page for configuring station mode and Network Settings.

Setting the Edge Controller

Mode: Select the mode Edge Controller

Product Model And Accessory: Depending on the type of Turbine hardware, there are different Product models and accessories to choose from. Find your model here: Turbine Station Models

IP Settings:

• DHCP – Select this option if the IP station shall receive IP Settings from a DHCP server.
• Static IP – Select this option if the IP station shall use a static IP address. Enter values for:
  • IP-address
  • Subnet-mask
  • Gateway
  • DNS Server 1 (option for network administration)
  • DNS Server 2 (option for network administration)
  • Hostname (option for network administration)

• Disable Reset to Factory default settings using frontboard and I/O : If enabled, factory reset will only be possible from StationWeb. This is disabled by default.
• Read IP Address [Turbine only]: Check the Read IP Address box to enable an unregistered station to speak the IP address when the call button is pressed. "Read IP Address" is default enabled.
• Enable RSTP [Turbine only] (for Industrial & Ex stations): Check the Enable RSTP box to enable RSTP. RSTP is only required when using redundant networking
• Ethernet Speed 10 Mbits/s [Turbine only]: Enable in some rare cases where it is not convenient to use 100 MBit/s Ethernet speed. Default Ethernet speed is 100 Mbit/s unless switch is configured to 10 Mbit/s.

Click Save to apply the new configuration settings.