Difference between revisions of "Event Handler macros"
From Zenitel Wiki
(New page: Event handle macros is used within Event handler action strings. There are macros for * getting parameters of the event. * Getting state or configuration information * doing calculati...) |
(No difference)
|
Revision as of 09:32, 10 August 2010
Event handle macros is used within Event handler action strings. There are macros for
- getting parameters of the event.
- Getting state or configuration information
- doing calculations
Pages in category "Event Handler macros"
The following 54 pages are in this category, out of 54 total.
%
- %1.brd
- %1.dak
- %1.dev
- %1.dir
- %1.exp
- %1.fea
- %1.mfre
- %1.mpri
- %1.nam
- %1.nod
- %1.phy
- %1.port
- %1.udp
- %busy
- %chg
- %clk
- %ges
- %gns
- %gnv
- %lbd
- %mch
- %mcm
- %nip
- %op
- %paf
- %pai
- %pap
- %prci
- %prco
- %prog
- %rdir
- %rn
- %rphy
- %scmp
- %scutc
- %scutf
- %sev
- %sfg
- %sgm
- %sng
- %sscan
- %strlen
- %sxc
- %syse
- %syspar
- %tin
- %tmp
- %tnsf
- %tnss
- %tnst
- %udd
- %vol