Difference between revisions of "Private mode"
From Zenitel Wiki
Line 1: | Line 1: | ||
− | [[File:Private mode2.PNG|thumb|300px|right|State test of station private/open mode. "Always Open" flag was added in software 11.3.3.1 ]] | + | [[File:Private mode2.PNG|thumb|300px|right|State test of station private/open mode. "Always Open" flag was added in AMC software 11.3.3.1 ]] |
When calls are made to a station in '''Private mode''', the station will be ringing like a telephone, and the called user has to accept the call by pressing the [[M-key]] or lift the handset. | When calls are made to a station in '''Private mode''', the station will be ringing like a telephone, and the called user has to accept the call by pressing the [[M-key]] or lift the handset. | ||
Revision as of 16:13, 25 October 2013
When calls are made to a station in Private mode, the station will be ringing like a telephone, and the called user has to accept the call by pressing the M-key or lift the handset.
Private mode can be set:
- By selecting "Private" mode on the station. Most station types has a switch or a jumper on the circuit board to set the station in Private mode. On IP stations one must press the C-button for 3 seconds.
- By enabling the Programable Open/Private in AlphaPro, then dial 7887 to set the station in Private mode.
- By setting the "Always Private" flag in AlphaPro
Note: When using the feature Programable Open/Private, the current state (private or open) is stored in state data, thus will be removed during "chilly reset".
On IP stations the private mode is toggled by holding the C-key pressed in idle. Controlling private/open by C-key is disabled if:
- The IP station is of hardware type without display, (I.e. no keyboard)
- "Always Private" flag is set
- "Always Open" flag is set
The use of C-key on IP station will simultaneously set both the state of "current programmed private mode" and "state of hardware switch".