Difference between revisions of "RCO - Set Remote Control Output"
From Zenitel Wiki
(→Syntax) |
|||
| Line 1: | Line 1: | ||
| − | The RCO command is used for controlling [[RCO|Remote Control Outputs (RCOs)]], which | + | The RCO command is used for controlling [[RCO|Remote Control Outputs (RCOs)]], which is used for operating relays on the [[MRBD]] board or the relay in the IP station. |
== Syntax == | == Syntax == | ||
Revision as of 13:21, 24 September 2008
The RCO command is used for controlling Remote Control Outputs (RCOs), which is used for operating relays on the MRBD board or the relay in the IP station.
Syntax
RCO <RCO logical number> <ON/OFF> <Pulse time>
Example
RCO 10 - The RCO number 10 will follow the event ON and OFF RCO 10 ON – Turns ON the RCO number 10 RCO 10 ON 25 – Pulse RCO number 10 for 2.5 seconds