RCO - Set Remote Control Output

The RCO command is used for controlling Remote Control Outputs (RCOs), which is used for operating relays on devices supporting Remote Control Outputs, such as the MRBD board, the FBSAR board or the relay in the IP station.

Syntax

RCO  <RCO logical number>  <ON/OFF>   <Pulse time>

Example

RCO 10         - The RCO number 10 will follow the event ON and OFF
RCO 10 ON      – Turns ON the RCO number 10
RCO 10 ON 25   – Pulse RCO number 10 for 2.5 seconds

Application example

Pulsing of RCO (Event Handler)