Difference between revisions of "Remote setup of Alarm message feature"
From Zenitel Wiki
| Line 17: | Line 17: | ||
|} | |} | ||
<br> | <br> | ||
| + | This feature is by default available for [[SuperUser]] only. | ||
| + | |||
Alarm messages can also be triggered from the [[Event Handler]] or [[RCI]] by using the commands [[AMS]] or [[AMG]], or the [[ACDP|AlphaCom Data Protocol]] command [[ALARM MSG|$ALRM]] | Alarm messages can also be triggered from the [[Event Handler]] or [[RCI]] by using the commands [[AMS]] or [[AMG]], or the [[ACDP|AlphaCom Data Protocol]] command [[ALARM MSG|$ALRM]] | ||
<br><br> | <br><br> | ||
Revision as of 09:08, 20 September 2016
| Feature: | Remote setup of Alarm Message |
| Default directory number: | 761 |
| Feature number: | 68 |
| Parameter 1: | 0 (N/A) |
| Description: | Remotely activate playback of alarm message to another station or group of stations. The feature requires ASVP board.
Procedure:
|
This feature is by default available for SuperUser only.
Alarm messages can also be triggered from the Event Handler or RCI by using the commands AMS or AMG, or the AlphaCom Data Protocol command $ALRM
By default an alarm message will be repeated endlessly, until switched off. However, it is possible to specify a specific number of repetitions for each alarm message. This must be done from the nvram editor in the TST console.