Upgrade from Pulse to IC-EDGE

This article is under construction!

This article describes how to upgrade from Pulse system (VS-IS 4.x) to an IC-EDGE System.

Prerequisite

• Pulse (VS-IS 4.x) can be upgraded to Edge, but the whole system needs to run with the same Turbine software (VS-IS 5.0 or newer).
• In an IC-EDGE System, INCA stations cannot be used as the Edge Controller.
• TCIV video intercoms should not be used as the Edge Controller for systems exceeding 4 devices.
• VS-IMT can be used for station discovery and upgrade, but should not be used to configure Edge.

Pulse to Edge Licenses

Pulse licenses will be honored in an IC-EGDE System. This means that when you upgrade firmware from VS-IS 4.x to 5.x your Pulse licenses will work for Edge.
More information regarding licensing in Edge can be found here.

Select IC-EDGE Controller

If the current Pulse Server is an Inca station you must select a different device (Turbine) as the IC-EDGE Controller.
Maximum number of devices with TCIV as the IC-EDGE Controller is 4.

Upgrade the Stations

In an IC-EDGE system all station must be upgraded to IC-EDGE. You cannot mix IC-EDGE and Pulse devices.
Make sure all Turbine station runs 5.0.3.0 or newer.
Inca stations must run 02.10.3.0 or newer.
Software can be found here.

Upgrade procedure using VS-IMT can be found here.
Manual upgrade procedure can be found here.

IC-EDGE Configuration

Detailed information on how to configure IC-EDGE can be found here.