Difference between revisions of "Upgrade from Pulse to IC-EDGE"
From Zenitel Wiki
(→Select IC-EDGE Controller) |
(→IC-EDGE Configuration) |
||
Line 25: | Line 25: | ||
Manual upgrade procedure can be found [[Turbine_Software_Upgrade|here]]. | Manual upgrade procedure can be found [[Turbine_Software_Upgrade|here]]. | ||
− | == | + | == Edge Configuration == |
− | Detailed information on how to configure | + | Detailed information on how to configure Edge can be found [[IC-EDGE_-_Getting_started|here]]. |
[[Category: IC-EDGE Configuration]] | [[Category: IC-EDGE Configuration]] |
Revision as of 13:16, 11 September 2019
This article describes how to upgrade from Pulse system (VS-IS 4.x) to an IC-EDGE System.
Contents
Prerequisites
- When upgrading a Pulse System to Edge, all devices needs to run the same Turbine software (VS-IS 5.0 or newer).
- In an IC-EDGE System, INCA stations cannot be used as the Edge Controller.
- TCIV video intercoms should not be used as the Edge Controller for systems exceeding 4 devices.
- VS-IMT can be used for station discovery and upgrade, but should not be used to configure Edge.
Pulse to Edge Licenses
Pulse licenses will be honored in an IC-EGDE System. This means that when you upgrade firmware from VS-IS 4.x to 5.x your Pulse licenses will work for Edge.
More information regarding licensing in Edge can be found here.
Select Edge Controller
The Edge Controller must be a Turbine device. If the current Pulse Server is an Inca station, you must select a different device (Turbine) as the Edge Controller.
Upgrade the Stations
In an IC-EDGE system all station must be upgraded to IC-EDGE. You cannot mix IC-EDGE and Pulse devices.
Make sure all Turbine station runs 5.0.3.0 or newer.
Inca stations must run 02.10.3.0 or newer.
Software can be found here.
Upgrade procedure using VS-IMT can be found here.
Manual upgrade procedure can be found here.
Edge Configuration
Detailed information on how to configure Edge can be found here.